Electronics
  • No categories

L298N Mini Dual H-Bridge Motor Driver Board

රු360.00
  • Mini L298N 2 Channel H Bridge DC Motor Driver Board: Can drive two DC motors or a 4-wire 2-phase stepper motors ,can achieve forward rotation or reverse rotation, it is possible to adjust the rotation speed.for Electric Projects, Smart Car Robot
  • Supply voltage: 2~10V
  • Input Voltage: 1.8~7V
  • Output Current: Single Operating current 1.5A, peak current up to 2.5A, low standby current (less than 10uA)
  • Use of imported original chip, built-in low on-resistance MOS switch, minimal heat, no heat sink, small size, low power consumption, is ideal for battery powered

DC 3-6V Yellow Double Axis L ShapeTT Motor Plastic Gear Motor

රු375.00
  1. 95RPM BO Motor Single Side
  2. Type: Single Side
  3. Shaft Diameter: 5.3mm(Double D-Type)
  4. Shaft Length: 9mm

MQ-6 Liquefied Petroleum Isobutane Propane Gas Sensor module

රු380.00
  • Model: MQ-6
  • Operating Voltage: 5V DC
  • Detecting Range:200-10000 ppm
  • Relative Humidity:<95% RH

DHT11 Temperature And Humidity Sensor Module with LED

රු380.00
  • Input Supply voltage (VDC): 3.3 ~ 5
  • Supply Current (mA): measurement 0.3mA standby 60μA.
  • Temperature measurement range: 0~50 degrees
  • Temperature measurement error: ±2 degrees
  • Humidity measurement range: 20%~95%RH
  • Humidity measurement error: ±5%RH

MQ-3 Alcohol Detector Gas Sensor Module

රු410.00
  • ower requirements: 5 VDC @ ~165 mA (heater on) / ~60 mA (heater off).
  • Current Consumption: 150mA.
  • DO output:  0.1 and 5V.
  • AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V
  • Detecting Concentration: 0.05-10mg/L Alcohol.

L298N Based Motor Driver Module

රු410.00
  • gical voltage: 5V
  • Drive voltage: 5V-35V
  • Logical current: 0-36mA
  • Drive current: 2A (max. single bridge)
  • Max power: 25W
  • Dimensions: 44 x 44 x 28 (LxWxH)mm
  • Weight: 26 gm
 

MQ-7 CO Carbon Monoxide Coal Gas Sensor Module

රු430.00
  • Operating voltage: DC 5 V.
  • The analog output voltage, the higher the concentration the higher the voltage.
  • The carbon monoxide detection with better sensitivity.
  • With a long service life and reliable stability.
  • Rapid response and recovery characteristics.
  • Range: 10 to 1000 ppm

140pcs Breadboard Jumper Wires Solderless Kit 22 AWG with Box

රු440.00
  • 140 quality jumper
  • Color: red, orange, yellow, green, blue, purple, gray, brown, white
  • Box size: approx. 165 x 55 x 10mm
  • The length of the line is not the same length, the length of the line, a total length of 14 lengths 10 each, a total of 140
  • 140pcs of 22 AWG solid wires
  • Including lengths: 2, 5, 7, 10, 12, 15, 17, 20, 22, 25, 50, 75, 100, and 125mm (10pcs each length)

2 channel 5V DC Relay Module

රු440.00
  • Low-level trigger (15-20mA per channel)
  • Controls up to AC 250V 10A / DC 30V 10A
  • Directly compatible with Arduino, Raspberry Pi
  • Optocoupler isolation for safety
  • Independent control of 2 devices
  • LED status indicators
  • Easy integration with standard interface

MQ-8 Hydrogen Gas Sensor Module H2 Alarm Detection

රු450.00
  • Using high-quality dual-panel design, with power indicator and TTL signal output instructions.
  • The switching signal having a DO (TTL) output and analog output AO.
  • TTL output valid signal is low.
  • The higher the voltage, the concentration of the analog output voltage is higher.
  • A hydrogen gas detection with good sensitivity.
  • Has a long life and reliable stability

GY-271 HMC5883L 3-Axis Compass Magnetometer Module

රු450.00
  • 3-Axis magneto-resistive sensor
  • 1 to 2 degree compass heading accuracy
  • Wide magnetic field range (+/-8 gauss)
  • Fast 160 Hz maximum output rate
  • Precision in-axis sensitivity and linearity
  • Measures Earth’s magnetic field, from milli-gauss to 8 gauss

MQ-9 Carbon Monoxide, Methane and LPG Gas Sensor Module

රු480.00
  • Good sensitivity to CO/Combustible Gas
  • High sensitivity to Methane, Propane, and CO
  • Long life and low cost
  • Simple drive circuit
  • Input voltage: DC 5±0.2V
  • Current Consumption: 150mA