Electronics
- No categories
PS2 Joystick Module Breakout Sensor
රු130.00- Dimensions: 34 x 34 x 15 (LxWxH) mm.
- Weight: 10gm (without Hat).
- 2.54mm pin interface leads.
- Operating Voltage: 5V.
- Long service life and stable performance.
- Standard interface and electronic building blocks.
- Widely use in Arduino DIY projects.
Rain Drop Sensor Module
රු250.00- Adjustable sensitivity
- Output LED indicator
- Compatible with Arduino
- Operating voltage: 5V
- Provide both digital and analog output
- Adjustable sensitivity
Rain Water Level Sensor Depth Detection
රු120.00- Operating voltage: DC3-5V
- Operating current: less than 20mA
- Sensor Type: Analog
SIM900 Quad-Band GSM GPRS Shield with Antenna
රු2,450.00- Compatible with Arduino and its clones
- Quad Band 850 / 900/ 1800 / 1900 MHz GSM network
- Can send and receive SMS, MMS, GPRS and audio using GSM network.
- Supports UART interface
- AT commands
- Embedded TCP/UDP stack facility for uploading data to a web server
- RTC support
- Speaker and Headphone jacks
- Equipped with 12 GPIOs, 2 PWMs, and an ADC
TCRT5000 Infrared Line Tracking Sensor
රු175.00- Working voltage of 3.3V to 5V
- Output form: digital switch output (0 and 1)
- Using infrared reflection sensors TCRT5000
- Test reflection distance: 1mm to 25mm
TCRT50003-pin Line Hunting Sensor Module
රු200.00- Supply Voltage: 3.3V~5V
- Detect distance: 1mm-8mm
- Digital Outputs LOW when objects detected
- On-board indicator LED to show the results
- On-board potentiometer to adjust the sensitivity
- On-board LM393 chip
TCRT5000L Infrared 5 Channel Tracking Sensor
රු890.00- Applicable to a variety of platforms including for Arduino /AVR/ARM/PIC
- High-Quality Tracker Sensor
- The module is a convenient carrier for eight IR emitter and receiver pairs evenly paced.
- Distance between each IR Sensor: 15mm
- Uses 5 sensors for best resolution
- Great useful in building fast line following and grid navigating robots
TP4056 5V 1A Micro USB 18650 Special Lithium Battery Charging Module (With Protection)
රු70.00- Input Voltage: 5V
- Maximum Charge Current: 1000mA.
- Board Size: 17.16 mm x 26.17 mm.
- Charging cut-off voltage: 4.2V ± 1%.
- Battery overcurrent protection current: 3A.
- Battery over-discharge protection voltage: 2.5V.
TTP223B Digital Sensor Module Capacitive Touch Switch
රු150.00- Power supply voltage(VCC): 2.0, 3, 5.5 V.
- Output high VOH: 0.8VCC V
- Output low VOL: 0.3VCC V
- Response time (touch mode) : 60 mS
- Response time (low power mode) : 220 mS
- Can replace the traditional touch of a button
- Four M2 screws positioning holes for easy installation
Vibration SW-18010P Sensor Module
රු215.00- Working voltage : 3.3V ~ 5V
- Output type: Digital switching output (0 and 1)
- Wide voltage : comparator LM393
