Shop
- No categories
MQ-7 CO Carbon Monoxide Coal Gas Sensor Module
රු430.00- Operating voltage: DC 5 V.
- The analog output voltage, the higher the concentration the higher the voltage.
- The carbon monoxide detection with better sensitivity.
- With a long service life and reliable stability.
- Rapid response and recovery characteristics.
- Range: 10 to 1000 ppm
YP-05 FTDI FT232L USB to TTL Converter Module
රු420.00- Chip: FT232RL
- Draw out all signal port of FT232RL chip
- RXD / TXD transceiver communication indicator
- USB power supply, can choose 5V or 3.3V, set by jumper
- With over current protection, using 500mA self-restore fuse
- Pin definition: DTR, RXD, TX, VCC, CTS, GND
- Pitch: 2.54mm
- Size: 36 x 18mm (L x W)
- Interface: Mini USB
L298N Based Motor Driver Module
රු410.00- gical voltage: 5V
- Drive voltage: 5V-35V
- Logical current: 0-36mA
- Drive current: 2A (max. single bridge)
- Max power: 25W
- Dimensions: 44 x 44 x 28 (LxWxH)mm
- Weight: 26 gm
MQ-3 Alcohol Detector Gas Sensor Module
රු410.00- ower requirements: 5 VDC @ ~165 mA (heater on) / ~60 mA (heater off).
- Current Consumption: 150mA.
- DO output: 0.1 and 5V.
- AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V
- Detecting Concentration: 0.05-10mg/L Alcohol.
DHT11 Temperature And Humidity Sensor Module with LED
රු380.00- Input Supply voltage (VDC): 3.3 ~ 5
- Supply Current (mA): measurement 0.3mA standby 60μA.
- Temperature measurement range: 0~50 degrees
- Temperature measurement error: ±2 degrees
- Humidity measurement range: 20%~95%RH
- Humidity measurement error: ±5%RH
MQ-6 Liquefied Petroleum Isobutane Propane Gas Sensor module
රු380.00- Model: MQ-6
- Operating Voltage: 5V DC
- Detecting Range:200-10000 ppm
- Relative Humidity:<95% RH
DC 3-6V Yellow Double Axis L ShapeTT Motor Plastic Gear Motor
රු375.00- 95RPM BO Motor Single Side
- Type: Single Side
- Shaft Diameter: 5.3mm(Double D-Type)
- Shaft Length: 9mm
L298N Mini Dual H-Bridge Motor Driver Board
රු360.00- Mini L298N 2 Channel H Bridge DC Motor Driver Board: Can drive two DC motors or a 4-wire 2-phase stepper motors ,can achieve forward rotation or reverse rotation, it is possible to adjust the rotation speed.for Electric Projects, Smart Car Robot
- Supply voltage: 2~10V
- Input Voltage: 1.8~7V
- Output Current: Single Operating current 1.5A, peak current up to 2.5A, low standby current (less than 10uA)
- Use of imported original chip, built-in low on-resistance MOS switch, minimal heat, no heat sink, small size, low power consumption, is ideal for battery powered
MQ-4 High Sensitivity Gas Methane (CNG) Detector Sensor Module
රු360.00- Detecting range: 300~10000ppm
- Signal output indicator.
- Dual Signal output (analog output and TTL output).
- The TTL output signal is low level, allows us to connect with SCM directly.
- Analog output 0~5V voltage.
- Quick response and recovery.
Arduino Bluetooth Serial Transceiver Module Base Board For HC-06 HC-07 HC-05
රු290.00- The factory chip production , stable and reliable quality
- Power anti-reverse , reverse power does not work
- Input voltage 3.6 ~ 6V, must not exceed 7V! !
- common variety of models can be installed Bluetooth
- module , such as HC05, HC06, HC07, BC04 , or other
Hw-596 / Gy-68 Arduo Bmp180 Barometric Pressure Sensor Module
රු290.00- 1.8V to 3.6V Supply Voltage
- Low power consumption – 0.5uA at 1Hz
- I2C interface
- Max I2C Speed: 3.5Mhz
- Very low noise – up to 0.02hPa (17cm)
- Fully calibrated
HC-SR505 Mini Infrared PIR Motion Sensor Infrared Detector Module
රු290.00- Automatic induction: to enter the sensing range
- Ultra-small size.
- Repeatable trigger
- Wide operating voltage range
- Micropower: quiescent current <50
- Output high signal: easy docking and all kinds of circuits.
