DRV8825 Stepper Motor Driver Module

Rs 370.00

3D Printer parts StepStick DRV 8825 DRV8825 Stepper Motor Driver Module Reprap 4 PCB Board replace A4988

Out of stock

Specifications:

A simple steps and direction control interface
six different steps resolutions: full-step, half step, 1/4-step1/8-step1/16-step, 1/32-step
CAN interface directly with 3.3 V and 5 V systems
Over-temperature thermal shutdown, overcurrent shutdown, Under voltage lockout
short to ground short circuit load protection
4 Layer 2 oz copper PCB, in order to improve heat dissipation
exposed solder ground below the bottom of the driver IC on the printed circuit board pad
module size, pin and interface matching A4988 stepper motor driver operators in many ways
adjustable current control lets you set a potentiometer, which lets you use the stepper motor’s rated voltage or more, in order to achieve a higher rate of maximum output current step
Intelligent chopping control automatically selects the correct current decay mode (fast decay or slow decay)
Maximum 45 V supply voltage
Built-in voltage regulator (the need for any external logic supply voltage)

There are no reviews yet.

If you have simply changed your mind or no longer require the item(s), you must notify us within 30 days from receiving your order.

The item(s) must be in their original unused and unopened packaging and be in a resalable condition for a full refund.

You will need to pay for the cost of returning the item(s) and the item(s) remain your responsibility until we receive them.

Damaged caused during transit must be notified within two days of the delivery.

All items sold as tested are genuinely tested before dispatch.
Product(s) which show obvious signs of misuse, damage or weather damage will not be eligible for refund or replacement.
All items are security marked.
Please ensure all security markings and stickers are intact or any warranty offered will be void.
All items are subject to satisfactory inspection of the anti-tamper warranty sticker/seal.
Any evidence that these aforementioned stickers/seals have been removed or broken will render the item out of warranty and will not be covered under warranty rules.
If the item becomes faulty within that period a replacement will be issued free of charge upon receipt of the faulty item, back to us, if proved to be faulty upon inspection.
If the item is not faulty or can be repaired, not to the detriment of the item, then this shall be undertaken rather than direct replacement.