A3967 EasyDriver Stepper Motor Driver

Rs 425.00

A3967 microstepping driver
MS1 and MS2 pins broken out to change microstepping resolution to full, half, quarter and eighth steps (defaults to eighth)
Compatible with 4, 6, and 8 wire stepper motors of any voltage
Adjustable current control from 150mA/phase to 750mA/phase
Power supply range from 7V to 20V. The higher the voltage, the higher the torque at high speeds

Out of stock

The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver). EasyDriver requires a 7V to 20V supply to power the motor and can power any voltage of stepper motor. The EasyDriver has an on board voltage regulator for the digital interface that can be set to 5V or 3.3V. Connect a 4-wire stepper motor and a microcontroller and you’ve got precision motor control! EasyDriver drives bi-polar motors, and motors wired as bi-polar. I.e. 4,6, or 8 wire stepper motors.

Note: Do not connect or disconnect a motor while the driver is energized. This will cause permanent damage to the A3967 IC.

Features:

A3967 microstepping driver
MS1 and MS2 pins broken out to change microstepping resolution to full, half, quarter and eighth steps (defaults to eighth)
Compatible with 4, 6, and 8 wire stepper motors of any voltage
Adjustable current control from 150mA/phase to 750mA/phase
Power supply range from 7V to 20V. The higher the voltage, the higher the torque at high speeds

Reviews

There are no reviews yet.

Be the first to review “A3967 EasyDriver Stepper Motor Driver” Cancel reply

If you have simply changed your mind or no longer require the item(s), you must notify us within 30 days from receiving your order.

The item(s) must be in their original unused and unopened packaging and be in a resalable condition for a full refund.

You will need to pay for the cost of returning the item(s) and the item(s) remain your responsibility until we receive them.

Damaged caused during transit must be notified within two days of the delivery.

All items sold as tested are genuinely tested before dispatch.
Product(s) which show obvious signs of misuse, damage or weather damage will not be eligible for refund or replacement.
All items are security marked.
Please ensure all security markings and stickers are intact or any warranty offered will be void.
All items are subject to satisfactory inspection of the anti-tamper warranty sticker/seal.
Any evidence that these aforementioned stickers/seals have been removed or broken will render the item out of warranty and will not be covered under warranty rules.
If the item becomes faulty within that period a replacement will be issued free of charge upon receipt of the faulty item, back to us, if proved to be faulty upon inspection.
If the item is not faulty or can be repaired, not to the detriment of the item, then this shall be undertaken rather than direct replacement.