L293D Motor Driver Expansion Board NodeMcu Lua ESP12E V2.0

Rs 675.00

L293D is a dual H-bridge motor driver integrated circuit (IC). Motor drivers act as current amplifiers since they take a low-current control signal and provide a higher-current signal. This higher current signal is used to drive the motors.

Out of stock

Feature:
Power input:
Motor power supply (VM): 4.5V ~ 36V, can be powered separately
Control power (VIN): 4.5V ~ 9V (10VMAX), can be powered separately
Module provides short-circuit sub (short the VM and VIN), you can easily use one power (must 4.5V ~ 9V) while completing motor drive and control
Logic Operating current Iss: ≤60mA (Vi = L), ≤22mA (Vi = H)
Drive part of the work current Io: ≤1.2A
Maximum power dissipation: 4W (T = 90 â„ƒ)
Control signal input level: High: 2.3V≤VIH≤VIN; Low: -0.3V≤VIL≤1.5V
Working temperature: -25 â„ƒ ~ + 125 â„ƒ
Drive Type: Dual high-power H-bridge driver
ESP12E Dev Kit Control Port: D1, D3 (A motor); D2, D4 (B motor)
Expand two-way motor-driven, two-way direct drive motor
Onboard power switch
Motor power, control power separation; In the experiment, by short-circuiting block the merger,

the VIN and VM short, while power to the motor and the control board

Notice:
When inserted into the ESP-12E module,

please note the direction consistent with an expansion board antenna
The use of short modules that can simultaneously control board and motor.

Package:

1 x L293D Wifi Motor Driver Shield Module For Arduino NodeMcu ESP8266 ESP-12E

Reviews

There are no reviews yet.

Be the first to review “L293D Motor Driver Expansion Board NodeMcu Lua ESP12E V2.0” Cancel reply

If you have simply changed your mind or no longer require the item(s), you must notify us within 30 days from receiving your order.

The item(s) must be in their original unused and unopened packaging and be in a resalable condition for a full refund.

You will need to pay for the cost of returning the item(s) and the item(s) remain your responsibility until we receive them.

Damaged caused during transit must be notified within two days of the delivery.

All items sold as tested are genuinely tested before dispatch.
Product(s) which show obvious signs of misuse, damage or weather damage will not be eligible for refund or replacement.
All items are security marked.
Please ensure all security markings and stickers are intact or any warranty offered will be void.
All items are subject to satisfactory inspection of the anti-tamper warranty sticker/seal.
Any evidence that these aforementioned stickers/seals have been removed or broken will render the item out of warranty and will not be covered under warranty rules.
If the item becomes faulty within that period a replacement will be issued free of charge upon receipt of the faulty item, back to us, if proved to be faulty upon inspection.
If the item is not faulty or can be repaired, not to the detriment of the item, then this shall be undertaken rather than direct replacement.