Voltage Detection Module

Rs 85.00

Voltage Detection Sensor Module 25V, For Electronic

Out of stock

Voltage Sensor is a precise low cost sensor for measuring voltage. It is based on principle of resistive voltage divider design. It can make the red terminal connector input voltage to 5 times smaller. Arduino analog input voltages up to 5V, the voltage detection module input voltage not greater than 5Vx5=25V (if using 3.3V systems, input voltage not greater than 3.3Vx5=16.5V).

Arduino AVR chips have 10-bit AD, so this module simulates a resolution of 0.00489V (5V/1023), so the minimum voltage of input voltage detection module is 0.00489Vx5=0.02445V.

Features:-

Voltage input range: DC 0-25V
Voltage detection range: DC 0.02445V-25V
Voltage Analog Resolution: 0.00489V
DC input connector: Terminal cathode connected to VCC, GND negative pole
Output interface: “+” connect 5/3.3V, “-” connect GND, “s” connect the Arduino AD pins

Reviews

There are no reviews yet.

Be the first to review “Voltage Detection Module” Cancel reply

If you have simply changed your mind or no longer require the item(s), you must notify us within 30 days from receiving your order.

The item(s) must be in their original unused and unopened packaging and be in a resalable condition for a full refund.

You will need to pay for the cost of returning the item(s) and the item(s) remain your responsibility until we receive them.

Damaged caused during transit must be notified within two days of the delivery.

All items sold as tested are genuinely tested before dispatch.
Product(s) which show obvious signs of misuse, damage or weather damage will not be eligible for refund or replacement.
All items are security marked.
Please ensure all security markings and stickers are intact or any warranty offered will be void.
All items are subject to satisfactory inspection of the anti-tamper warranty sticker/seal.
Any evidence that these aforementioned stickers/seals have been removed or broken will render the item out of warranty and will not be covered under warranty rules.
If the item becomes faulty within that period a replacement will be issued free of charge upon receipt of the faulty item, back to us, if proved to be faulty upon inspection.
If the item is not faulty or can be repaired, not to the detriment of the item, then this shall be undertaken rather than direct replacement.